Infrared radiant heaters on the ground floor, first floor and attic:

Operation:

If a temperature change is required, press the "mode" button.

The temperature can then be adjusted accordingly with + or -. Confirm by pressing the "mode" button.

The three devices are controlled manually separately for each radiant heater. The corresponding control element is located near each radiant heater.

Caution:

If "mode" is pressed too often, the heating is switched off. A small "off" appears on the display. Then press "mode" again to switch on.

Decentralized control:

The three Infra-Red radiant heaters can also be controlled decentrally via WLAN by the company Bergkultur. You can therefore also contact Bergkultur if you wish to adjust the temperature.

White radiant heaters (studio / entrance area)

The radiant heaters (temperature) are controlled via the thermostat remote control units located nearby.

The function is the same as the three infrared radiant heaters on the floors.

The control elements on the radiators are blocked, operation is exclusively via the thermostats.

Important

Please do not switch off the two devices, as they can no longer be controlled via remote maintenance. The next guests will thank you.

Please do not place any objects (clothes/towels, etc.) on these two appliances to dry them. These heat up considerably and guests risk damaging their clothes.