Jacuzzi

Instructions for use:

Always shower before use.

1) Open the lid fastening clips. Please do not sit/stand on the lid. This will break!

The lid should be released at the clips at the back and opened using the lift handle.

- Fold the rear half over the bar in the middle in the direction of the house onto the other half

- Place both halves upright towards the house

After use, replace the lid and secure the clips at the front.

2) Remove both filters and rinse them thoroughly under the shower to remove any deposits

3)Check the pH value of the water with a test strip from the cabinet. Add pH - or pH Plus (pH- is usually necessary). Only if the water looks cloudy or not good, press the Boost button once at the "Deep Blue" display. The water in the whirlpool should last up to a year until it is replaced!

4) Switch on the bubbler:

- Press the "Jets" button

- Adjust the right or left side with the middle wheel on the side of the house

- Adjust the strength with the first wheel on the left

6) Adjust the color of the light:

- switch on the light once using the "Light" button, then red is active

- other colors can then be activated with the following combination:

- switch off the light briefly and switch it on again immediately

Bluetooth code for audio system: 2288, name B40